Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. An exhaust system
- 8. Systems of start, ignition
   - 8.1.1. Introduction
      8.1.2. Technical characteristics
      - 8.1.3. The accumulator
         8.1.3.2. Removal and installation
      + 8.1.4. The Generator / system of additional charge of the accumulator
      8.1.5. Replacement of the holder of brushes and a regulator of pressure of the generator
      8.1.6. Check of system of start of the engine
      8.1.7. A starter
      8.1.8. An inlet gas pipeline
      8.1.9. A cable of gas/lever throttle заслонки (DB)
      8.1.10. A cable of management of gas (DB)
      8.1.11. A contour of fuel of the diesel engine
      8.1.12. Prestarting heating of diesel fuel
      8.1.13. The fuel thermostat
      8.1.14. The hydrovalve case
      8.1.15. A cable of gas/lever throttle заслонки (ДД)
      8.1.16. A cable of management of gas (ДД)
   + 8.2. Ignition system (petrol engines)
   + 8.3. System of prestarting heating (diesel engines)
   + 8.4. System of release of the fulfilled gases
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

8.1.3.2. Removal and installation

THE GENERAL DATA

The accumulator is located on a left-hand side of an impellent compartment or under back sitting.

Removal

PERFORMANCE ORDER

1. Disconnect a wire of the minus plug, and then плюсовой accumulator plugs.

2. Turn off a bolt and remove a fixing clip of the accumulator.

3. Remove the accumulator from the car.

Installation

Installation is spent upside-down removals.