Audi 100/A6

1990-1997 of release

Repair and car operation

Audi 100/A6
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and a partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
- 6. Fuel system
   + 6.1.2. Technical characteristics
   + 6.2. Multidot system of injection of fuel
   + 6.3. System of injection MPI/MPFI (6-cylinder engines)
   - 6.4. The power supply system of diesel engines
      6.4.2. Technical characteristics
      6.4.3. The air filter
      6.4.4. A rope of an accelerator and elements of a pedal of an accelerator
      6.4.5. The gauge of level of fuel
      6.4.6. A fuel tank
      + 6.4.7. The injecting pump
      6.4.8. Speed of idling and the maximum speed of work of engine AAS
      6.4.9. A mode of fast idling (engine AAS)
      6.4.10. Residual volume of fuel (engine AAS)
      6.4.11. Fuel injectors
      6.4.12. A control system of work of the diesel engine
      6.4.13. An inlet collector
   6.5. The device of service of heating
   6.6. Diagnostics of malfunctions of system of heating
   6.7. The conditioner: not only "pluses", but also "minuses"
   6.8. Rules of service of the conditioner
+ 7. An exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, a steering
+ 12. A body
+ 13. An electric equipment
+ 14. A good advice

6.4.4. A rope of an accelerator and elements of a pedal of an accelerator ACCELERATOR ROPE (AAS)
Removal

PERFORMANCE ORDER

1. Remove the panel of furnish and disconnect a rope from a pedal.

2. In an impellent compartment remove a fixing clip and disconnect a rope from the lever.

3. Remove a rope from the car.

Installation and adjustment

PERFORMANCE ORDER

1. Installation is spent upside-down removals. Adjust a rope tension so that the throttle lever concerned an emphasis by pressing an accelerator pedal.

ROPE OF THE ACCELERATOR WITH MECHANICAL ADJUSTMENT (ENGINE AAS)

Removal

PERFORMANCE ORDER

1. Turn the adjusting handle up to the end counter-clockwise.

2. Disconnect a rope from the lever and remove it from the car.

Installation

Installation is spent upside-down removals.

ACCELERATOR ROPE (EXCEPT ENGINES AAS)

Removal

PERFORMANCE ORDER

1. Remove the furnish panel.

2. Disconnect a rope from a pedal.

3. Turn off a nut, remove a washer and disconnect a rope from the gauge of position of a pedal. Remove a rope.

Installation
Installation is spent upside-down removals.